Most laser pointers we can buy and get are not with high power or not professional enough, but we can help you let your laser pointer becomes more powerful. The modified laser pointer projects a strong laser beam of light, like a professional laser pointers.

First of all, there is no doubt that you have to unscrew the battery cover from the laser pointer back side, remove the battery and also the front reflector laser pointer cap. And place them well.

Secondly, clamp l the jaws of the needle-nose pliers around the side of the laser assembly, which is prominent from the front of the laser pointer.

Thirdly, now you can take the circuit board out of laser pointer, and let it face up. Turn on the circuit board in the first quarter turn counter-clockwise using the flat edge of the jeweler’s screwdriver single screw.

Next, heat iron and use a single computer chip soldering iron tip in about 10 seconds next to the screws. What is the weakening of the chip, the laser beam intensity. Wait for the General Assembly for the laser cooling minutes.

Fifth, apply adhesive around the front edge’s inside rim of laser pointer.

Then, place laser pointer assembly, and don’t touch the adhesive on laser pointer for at least 3 hours.

Don’t forget to screw reflected back to the front of laser pointer.

With all this steps, you now have the same laser pointer but with more powerful beam. Have a try!!